USB Host mini in test fixture
The first batch of USB Host Minis is built, tested, and boards are available in store. It is designed to be employed in lightweight, battery-operated circuits, for example, used for digital camera control. It can also be used as general MAX3421E breakout board. Title picture shows the board proudly sitting in its’ own ghetto-style Sparkfun-inspired pogo bed.
The design follows Arduino Mini minimalistic approach. It is 3.3V only and mates quite nicely with Sparkfun 3.3V Arduino Pro Mini. Only essential control and GPIO signals are available – no power supplies, level converters, or even jumpers are provided due to lack of space. However, since rearranging control signals is often necessary, extra pads have been placed for this purpose. They can be seen on product picture at the top and to the left of MAX3421E IC.
The board has VBUS routed to 3.3V. Even though the voltage is lower than specified 5V, the shield has been tested to work flawlessly with numerous self-powered devices, such as digital cameras, as well as some bus-powered devices, such as Sandisk Cruzer flash drive. However, if 5V VBUS is necessary, board can be easily modified – the trace from 3.3V to VBUS can be cut and 5V applied using a pad placed on the board for this purpose. It can be arranged using single 5V supply; since Arduino Pro Mini has on-board LDO, 5V can be applied to VRAW and VBUS while shield will be getting its’ 3.3V power from Arduino board, as usual.
Bottom picture shows my favourite arrangement – Arduino Pro Mini sits on top of the shield with its’ programming connector easily accessible from either side. Also, Arduino reset switch is easily accessible this way.
Project files and schematic are available in Downloads section. If you have any questions about this design, e-mail me or leave a comment here.
Oleg.
USB Host Mini and Arduino Pro Mini
