Xbee on a breadboard
In the previous article, I described a simple wireless setup using a pair of Xbees connected to PIC microcontroller and serial port of a Linux machine. After finishing the article, I continued working on the project and that’s what I have found so far.
First, using router firmware in Xbee module is bad for your batteries. In this configuration power consumption is steady 40ma. In addition to that, sleep is not working. After loading end device firmware power consumption dropped to 5ma on average and I was able to use Sleep pin. Measured current in sleep mode is less than 1ua – not bad. Second, PIC18F4520 is not the best PIC for sensor applications. Newer K-series PIC18s with their internal 1.2V reference, such as PIC18F26K20, are much better. In addition, they can be clocked up to 64MHz, and they are cheaper. At the time of this writing PIC18F26K20 in DIP package sells for less than $4 in single quantities on Mouser.